Skip links

Suction scanner self-cleaning filter SCRO & SCRL

Suction scanner self-cleaning filter SCRO & SCRL

SUCTION SCANNER SELF CLEANING FILTER ASI316 (MEDIUM, BIG FLOW RATE)
MAIN TECHNICAL FEATURES:
  • Flow-rate uninterrupted even during washing phase
  • Filtration degree from 2000 to 25 μm on polyester mesh/ AISI316
  • Maximum flow rate 1000 m3/h with a single filter
  • Minimum amount discharge water
APPLICATIONS:
  • Pre-filtration in UF systems
  • Cooling towers
  • Spray nozzle protection
  • Heat exchangers
  • Seawater
  • Irrigation

Download Datasheet

Description

HOW IT WORKS

Water enters the filter through the IN inlet and goes through the filtering cylinder (4) from the inside to the outside. This will retain all non-deformable suspended solids that are the same size or bigger than the filtration degree installed. Filtered water leaves through the outlet pipe (OUT).

REGENERATION

The continuous settling of suspended solids inside the filtering cylinder (4) obstructs the passage of water which results in a pressure difference (∆P). At a preset value of ∆P (range 0.3 ÷ 1 Bar) an automatic cycle will start to clean the filter cylinder (4). This operation begins with a signal that opens the discharge valve (3) and creates communication between the suction nozzles (1) with the outside environment. At the same time, the electric motor (5) creates a rotating motion which enables the nozzles to inspect the filtering surface. Dirt is ejected through the discharge valve (3). The cleaning cycle lasts approximately 15 seconds.

CONTROL

A switchboard controls the washing phases. The signal that starts the cleaning cycle is given by a differential pressure switch or by time. The switchboard gives an “alarm” signal in case of problems in the washing system. These signals can be sent to a pre-existing control centre. The washing phase can also be controlled manually. The solenoid controlling the valve is pneumatic.

FILTER ELEMENT SECTION AND CLEANING SYSTEM

DIMENSIONI E DATI TECNICI | SCRL

SCR L 10 SCR L 15 SCR L 30 SCR L 45 SCR L 60 SCR L 75 SCR L 90 SCR L 130
Area filtrante (cm²) 1000 1500 3000 4500 6000 7500 9000 13000
Attacchi In/Out 2" 3" DN100 DN150 DN200 DN250 DN300 DN350
Attacchi Scarico 1" F 1" F 1"1/2 F 1"1/2 F 1"1/2 F 1"1/2 F 1"1/2 F 2" F
Attacchi svuotamento 1/2" F 1/2" F 1/2" F 1/2" F 1/2" F 1/2" F 1/2" F 1" F
Extra portata richiesta in lavaggio a 1 Bar con rete da 125 micron – m³/h 4 4 7 9 9 12 12 15
Durata del lavaggio – Sec. 15 15 15 15 15 15 15 15
Pressione min-max – Bar 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10
Temperatura max - °C 40 40 40 40 40 40 40 40
Alimentazione elettrica – Volt 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz
Potenza richiesta – Watt 90 90 180 180 180 370 370 550
Elettrovalvola – Volt /Watt 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6
Alimentazione pneumatica - Bar 2 - 8 2 - 8 2 - 8 2 - 8 2 - 8 2 - 8 2 - 8 2 - 8
Certificati di costruzione CE CE CE CE CE CE CE CE
Massima dimensione di particelle in ingresso *– mm 3 3 3 3 3 3 3 3
Massimo totale solidi sospesi in ingresso 125 micron– mg/l 100 100 100 100 100 100 100 100
A (mm) 757 903 1071 1309 1755 2027 2581 3181
B (mm) 470 485 607 635 706 791 969 929
C (mm) 327 327 423 423 516 714 852 852
D (mm) Estrazione cartuccia 450 534 600 885 1130 1160 1160 1690
PESO a vuoto Kg 28 34 51 64 75 90 116 285
PESO in lavoro Kg 36 46 68 106 133 206 346 598

DIMENSIONI E DATI TECNICI | SCRO

SCRO 10 SCRO 15 SCRO 30 SCRO 45 SCRO 60 SCRO 75 SCRO 90 SCRO 130
Area filtrante (cm²) 1000 1500 3000 4500 6000 7500 9000 13000
Attacchi In/Out 2"-3" 2"-3" 3" DN100 DN150 DN100 DN150 DN200 DN150 DN200 DN250 DN150 DN250 DN200 DN250 DN350
Attacchi Scarico 1" 1/2F 1" 1/2F 2" F 2" F 2" F 2" F 2" F 2" F
Attacchi svuotamento 1/4" F 1/4" F 1/4" F 1/4" F 1/4" F 1/4" F 1" F 1" F
Extra portata richiesta in lavaggio a 1 Bar con rete da 300 a 25 micron – m³/h 2 3 7 9 11 11 13 15
Durata del lavaggio – Sec. 15 15 15 15 15 15 15 15
Pressione min-max –Bar 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10 0,5-10
Temperatura max - °C 40 40 40 40 40 40 40 40
Alimentazione elettrica – Volt 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz 400 50/60 Hz
Potenza richiesta –Watt 90 90 180 180 180 370 370 550
Elettrovalvola – Volt /Watt 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6 24 AC / 6
Alimentazione pneumatica - Bar 2 – 8 2 – 8 2 – 8 2 – 8 2 – 8 2 – 8 2 – 8 2 – 8
Certificati di costruzione CE CE CE CE CE CE CE CE
Massima dimensione di particelle in ingresso *– mm 3 3 3 3 3 3 3 3
Massimo totale solidi sospesi in ingresso 125 micron– mg/l 100 100 100 100 100 100 100 100
A (mm) 900 1045 1430 1675 1920 2100 2205 2576
B (mm) 415 415 540 540 630 791 904 1114
C (mm) 330 330 410 430 460 634 678 870
D (mm) *Estrazione cartuccia 450 537 840 885 1130 1160 1160 1690
PESO a vuoto Kg 37 55 81 125 200 225 230 285
PESO in lavoro Kg 38 56 116 222 370 470 570 633

FILTERING MESH FLOW RATE TABLE FOR SCR FILTERS (m³/h)

MODEL 500 µm PES AISI316 300 µm PES AISI316 200 µm PES AISI316 120 µm PES AISI316 80 µm PES AISI316 50 µm PES AISI316 25 µm PES AISI316
SCR 2-10 30 30 30 30 30 26 13
SCR 3-15 50 50 50 50 50 39 19
SCR 100-30 147 147 147 147 111 78 34
SCR 150-45 216 216 216 216 166 117 59
SCR 200-60 373 373 373 315 222 156 78
SCR 250-75 573 573 573 395 277 195 98
SCR 300-90 720 720 720 473 333 234 117
SCR 350-130 1038 1038 1038 682 373 338 169

The flow rates indicated refer to a load loss of 0.2 Bar with clean, filtered water.

Additional information

Applicazione

, , , , , , , , , , ,

Scopri
Drag